Posted on Leave a comment

Create Your Very Own Carbon Transfer Paper

One major problem all commercial carbon transfer paper have is that its not easy to get rid of the accidental lines and smears made during transfers. If all those lines are going to be covered by your pyrography pen, that’s all well and good. But what if they don’t get covered with your design?

 

The best way to get rid of them would be to sand off the affected area. Naturally, the darker the lines, the more sanding is needed. Furthermore, you can’t just sand that affected area if you want your whole work piece to be level. You would need to sand everything down.

 

We don’t understand why transfers made from commercial carbon transfer paper cannot be erased by a simple rubber eraser. However, we have found an alternative that works quite well and is completely erasable – not to mention reusable too. Think of the savings! You probably already have all the materials in your house right now too so this is going to be an easy few minutes of a little elbow grease.

 

Check out the short video clip below, see if it works for you or not and share your experience with all of us through the comments below.

 

 

All the best,
Pavel Karoukin
hello@truart.co